Thermox ITF Physical Properties


1.08 -1.2 g/cm³ depending on inhibitors


7.5 - 10.5 depending on inhibitors

Boiling Point:



a clear, slightly viscous liquid. It is mildly sweet to the taste and has a non-pungent but characteristic aroma.

Available in:

5, 10, 15, 20, 25, 205 & 1000 litre containers and bulk tankers.


For a quote or assistance

Tel: (021) 385 0908

Industrial Grade Heat Transfer Fluid with Antifreeze, for use in Geothermal & Air Source Heat Recovery Systems. Based on Ethylene Glycol and BS6580 & ASTM D1384 proven Corrosion, Scale and Biological Inhibitors.

Thermox ITF has been especially formulated for use as an Industrial Grade Heat Transfer Fluid for use in Geothermal and Air Source Heat Recovery Systems.

Antifreeze AntiFreeze

Thermox ITF is miscible with water in all proportions and can protect geothermal and air source heat recovery systems down to -50°C depending on concentration.

Thermox ITF exhibits super-cooling characteristics and mixtures containing in excess of 55% by volume do not freeze solid, alleviating any concern over possible expansion and burst damage.

Optimum Flow Optimum Flow

Thermox ITF has improved heat transfer characteristics, including lower Dynamic Viscosity and higher Thermal Conductivity. For detailed comparison please refer to the performance curve - available upon request.

Corrosion control Corrosion Control

Thermox ITF contains synergistic corrosion inhibitors to protect metals commonly found in such systems. It has been tested in accordance with BS5117 and found to meet BS6580 and ASTM D1384 corrosion standards.

Thermox ITF also contains scale and biological inhibitors to help prevent fouling – thus promoting long operational life and high thermal efficiency.

Biodegradable Biodegradable

Thermox ITF mixtures are readily biodegradable (90% over ten days) and will not remain in the environment or bio-accumulate.

Quality Assured Quality Assured

All Hydratech products are manufactured in accordance with certified ISO9001-2008 procedures


As per BSRIA guide BG 29/2012 all pipe-work systems should be clean and free from biological contamination and debris prior to commissioning.

To minimise corrosion air ingress should be minimized. A pressurised system is best.

Determine the total system volume and add Thermox ITF to the system according to the minimum operating temperature required (see table). The minimum dose of Thermox ITF should not be less than 20% of the system volume and the maximum does not normally exceed 60%. We recommend the use of deionised, distilled or UltraPure™ water for this dilution. Avoid water containing high levels of calcium salts or Chlorides [Cl-].

Health & Safety: Please refer to the associated Safety Data Sheet Available via Login or upon request.

Shelf Life: 3 years when stored in sealed containers out of direct sunlight.

Available in: 5, 10, 15, 20, 25, 205 & 1000 litre containers and bulk tankers.

Thermox ITF can also be supplied as a Ready-To-Use solution.

Mixing Guide

Frost Protection °C v/v of Thermox ITF Refractive Index
-10 20% 1.349
-15 27% 1.355
-20 32% 1.359
-25 37% 1.363
-30 41% 1.366
-35 45% 1.369

When measuring the percentage of Thermox ITF in the system use a refractometer

back to all Thermox fluids